Mapeform MB 700

Form release agent based on highly refined mineral oils. Used as mould release agent on construction sites and in the precast industry.
 

PRODUCT DESCRIPTION

Mapeform MB-700 is well suited for casting on site, with moulds of plywood or wood. Mapeform MB-700 can also be used for casting of dry/no-slump concrete where demoulding takes place immediately or a short time after casting.

AREAS OF APPLICATION

Mapeform MB-700 prevents adhesion of concrete to all types of formwork used on construction sites and in the
precast industry. Mapeform MB-700 is applied as a thin layer of coating by spraying, brush or roller. The best result is achieved by use of pumps designed for mould release agents. Mapeform MB-700 is delivered ready to use.

TECHNICAL PROPERTIES
Mapeform MB-700 is a low viscosity mould release agent based on highly refined mineral oils.
Mapeform MB-700 contains rust inhibitors to protect steel formwork from corrosion. The product is easy to apply, 1 litre covers up to 40 m2. Mapeform MB-700 can be used down to -20°C.

• Easy demolding.
• Reduce amount of pin-holes and air pores in the
concrete surface.
• No discoloration of the concrete.
• Odourless.

PACKAGING

Mapeform MB-700 is available in 25 liter cans, 200 liter drums and in 1000 liter IBC tanks.

STORAGE
The product must be stored at temperatures between +8 and +35°C, and will retain its properties for at least
12 months if stored unopened in its original packaging. If the product is exposed to direct sunlight, colour
variation may occur, but this will not affect the technical properties of the product.

Colour: transparent

Appearance: liquid

For further and complete information about the product please find Technical Data Sheet (TDS).

 

 

Mapeform MB 700

Form release agent based on highly refined mineral oils. Used as mould release agent on construction sites and in the precast industry.
 

PRODUCT DESCRIPTION

Mapeform MB-700 is well suited for casting on site, with moulds of plywood or wood. Mapeform MB-700 can also be used for casting of dry/no-slump concrete where demoulding takes place immediately or a short time after casting.

AREAS OF APPLICATION

Mapeform MB-700 prevents adhesion of concrete to all types of formwork used on construction sites and in the
precast industry. Mapeform MB-700 is applied as a thin layer of coating by spraying, brush or roller. The best result is achieved by use of pumps designed for mould release agents. Mapeform MB-700 is delivered ready to use.

TECHNICAL PROPERTIES
Mapeform MB-700 is a low viscosity mould release agent based on highly refined mineral oils.
Mapeform MB-700 contains rust inhibitors to protect steel formwork from corrosion. The product is easy to apply, 1 litre covers up to 40 m2. Mapeform MB-700 can be used down to -20°C.

• Easy demolding.
• Reduce amount of pin-holes and air pores in the
concrete surface.
• No discoloration of the concrete.
• Odourless.

PACKAGING

Mapeform MB-700 is available in 25 liter cans, 200 liter drums and in 1000 liter IBC tanks.

STORAGE
The product must be stored at temperatures between +8 and +35°C, and will retain its properties for at least
12 months if stored unopened in its original packaging. If the product is exposed to direct sunlight, colour
variation may occur, but this will not affect the technical properties of the product.

Colour: transparent

Appearance: liquid

For further and complete information about the product please find Technical Data Sheet (TDS).

 

 

Susijusios sistemos