MAPEWRAP 21

Superfluid epoxy resin for impregnation of MapeWrap with “wet system”

WHERE TO USE

Impregnation immediately before placing MapeWrap fabrics that need to be applied on concrete, reinforced concrete or masonry elements to repair or strengthen.

TECHNICAL CHARACTERISTICS

MapeWrap 21 is a superfluid solvent-free epoxy resin based product specifically developed in the MAPEI Research & Development laboratories for the impregnation prior to placing MapeWrap fabrics.

MapeWrap 21 is made up of two pre-measured components (component A = resin and component B = hardener) that must be mixed together before use. After mixing, MapeWrap 21 remains workable for approximately 40 minutes at +23°C.

Once hardened, MapeWrap 21 acquires excellent dielectric properties and high mechanical strength.

MapeWrap 21 complies with the principles defined in EN 1504-9 (“Products and systems for protecting and repairing concrete structures: definitions, requirements, quality control and conformity evaluation. General principles for the use and application of systems”), and the minimum requirements for EN 1504-4 (“Structural bonding”).

PACKAGING

5 kg units (component A = 4 kg, component B = 1 kg).

STORAGE

MapeWrap 21 can be stored up to 24 months in its original sealed packaging at temperatures not below +10°C

For further and complete information about the product please find Technical Data Sheet (TDS).

 

MAPEWRAP 21

Superfluid epoxy resin for impregnation of MapeWrap with “wet system”

WHERE TO USE

Impregnation immediately before placing MapeWrap fabrics that need to be applied on concrete, reinforced concrete or masonry elements to repair or strengthen.

TECHNICAL CHARACTERISTICS

MapeWrap 21 is a superfluid solvent-free epoxy resin based product specifically developed in the MAPEI Research & Development laboratories for the impregnation prior to placing MapeWrap fabrics.

MapeWrap 21 is made up of two pre-measured components (component A = resin and component B = hardener) that must be mixed together before use. After mixing, MapeWrap 21 remains workable for approximately 40 minutes at +23°C.

Once hardened, MapeWrap 21 acquires excellent dielectric properties and high mechanical strength.

MapeWrap 21 complies with the principles defined in EN 1504-9 (“Products and systems for protecting and repairing concrete structures: definitions, requirements, quality control and conformity evaluation. General principles for the use and application of systems”), and the minimum requirements for EN 1504-4 (“Structural bonding”).

PACKAGING

5 kg units (component A = 4 kg, component B = 1 kg).

STORAGE

MapeWrap 21 can be stored up to 24 months in its original sealed packaging at temperatures not below +10°C

For further and complete information about the product please find Technical Data Sheet (TDS).

 

Artūras Ručinskas

Artūras Ručinskas

Projektų vadovas - inžinierius

El. paštas: arturas@velvemst.lt
Tel.: +37064020969

Susiję projektai